3 kawasakis - $3,800 (Bankston)

First bike is a 2004 Kawasaki Vulcan 1500 classic, I have all the parts for it.
All the chrome and body is good except two small dents near the gas cap.
I have the ignition key and gas cap key.
Bill of sale only no title.
This bike is almost done just missing a spark.
Has new ignition coils just don’t have time to track wires back.
Engine turns over and try’s to crank just no spark Second bike is a 1994 Kawasaki Vulcan 750.
I bought it and drove it and hour home and rode it no problems for several months before I let it sit and I took it out for a ride and blew the starter relay.
Changed it for a new one and now the starter button won’t turn the engine over but straight wiring the starter turns over just fine.
Saddle bags come with it.
Got them off an old Harley.
No rust or body damage.
Mufflers flip up at 90 degrees.
Bill of sale and title Third bike is a 1972 Kawasaki g4tr 100 an old dual sport with a dual range 10 speed transmission.
Good bike I swapped the engine out to a same year that had been rebuilt professionally.
Cranks on choke, runs for a bit and sputters out.
Needs new points and condenser.
I have a same model engine that’s complete and has all the parts just don’t have time to remove the fly wheel and get the point and condenser board out.
The seat has been reupholstered and the gas tank has a small dent in the bottom left side that I packed with body filler and cleaned up, ready to be sanded and painted.
Two stroke oil reservoir has a little rust putting but still holds fluid.
Also have a new/used front fender.
All the chrome is good comes with old engine/parts.
Bill of sale no title needed Overall they all just need a few things.
I’m being deployed seas in a few months and am just trying to downsize.
I’d like to get most of my money out of all the bikes but I don’t mind taking a little bit.
Right now I’ve got about 3500-4000 tied up between all three.
Just trying to find them a new home.
I’ll take cash and am open to all trades, I don’t mind if they run or not I’ll fix them up when I get back.
I’m looking for an older flat bed truck preferably an old 70s-90s ford, but I’m open to anything.
I’m a machinist so if you have mills or lathes you need gone I’m open to basically anything.